This guide will show you how to configure the Vigor2860 router to connect to AAPT NBN connection.
Note: This guide only applies to AAPT and may not apply to other NBN providers. You will need to check with the NBN provider for the configuration parameters required for step 2.
Step 1 - Connect to the router Admin page
Use your internet browser to login to the router web interface
(The default IP address for the router is 192.168.1.1)
Default username and password are as given below:
User name: admin
Password: admin
Step 2: Configure WAN Interface
Go to Internet access>>General Setup configuration menu
1). Select WAN2
2). Select Enable: “Yes” and click “OK”
The router will now restart.
Step 3: Configure WAN Internet Access
After the router has restarted log into the router again and go to the admin page.
Go to WAN >> Internet Access configuration menu.
1). Select access mode to “Static or Dynamic IP” for WAN2
2). Click on “Details Page”
3). Select “Obtain an IP address automatically” or “Specify an IP Address” based on the details received from ISP
4). Enter static IP address, subnet mask and gateway address if you have selected “Specify an IP Address” option
5). Click Ok
Router will restart again.
Step 4: Check the connectivity
After the router has restarted log into the router again and go to the admin page to check your connection.
Go to Online Status>>Physical Connection menu
If you see WAN2 status as all green it means your NBN connection is connected successfully. You can now check your internet access.
